Thursday, 3 July 2008

Accordian Books

I really enjoy making small books such as notebooks, matchbooks, stitched books and books with small pockets and pop-ups. From making the first proto-type the possibilities are endless and you need very few tools either.
There is such a great range of papers and cardstock available today to make hand made books with. I have used pre-printed gift wrap and good quality cartridge paper to make this small accordian folded book but I also like to dye my own paper and use batik papers too.

You will need:
1 sheet A3 cartridge paper
1 piece of card stock
1 sheet fancy paper (for your book cover)
scalpel or similar cutting knife
cutting mat or board
good quality paper glue
thin ribbon (not shown)
sharp scissors (not shown)

First, cut 3 pieces of card stock, using a ruler and scalpel. Accurate cutting is key here. 2 x 3" square (8cm) and 1 x 1" x 3" (3cm x 8cm). Next cut a piece of your fancy paper 7.5" x 3.5" (19cm x 9cm).

Cover each piece of card stock with an even coating of glue. I have used a gel glue but, if your paper glue is a particularly thick kind, leave it for 30 seconds to dry slightly before placing it on the fancy paper. I position the card stock on the paper "by eye" but you may want to measure the position and mark lightly with a pencil on the back of the fancy paper.
Make sure you leave a tiny space between each piece of card so that folding the book cover will not overstretch your paper.

To avoid smudging the glue onto the paper it is advisable to make your book in stages. I place the book cover under a heavy weight (such as a book or the cutting mat) and allow it to dry for 30 minutes. If you do not press your book flat the thin glue will cause it to warp and become misshapen.
Once the glue is thoroughly dry, use sharp pointed scissors to carefully snip the edges of the fancy paper, as shown above. You should also make a small vertical cut at each end of the book's spine. as shown below. This will prevent the paper from bunching around the spine.

Carefully fold down and glue the paper edges over the card stock, taking care not to over-wet the paper with glue. Resist the urge to fold the book yet, instead place it under a weight for another 30 minutes.

Once dry, cut two lengths of thin ribbon and glue these onto the inside of the book, back and front, as shown above. Leave to dry whilst you make the book pages.

Constructing the pages. You will need to measure and cut two strips of cartridge paper 2 3/4" (7cm) x the length of an A3 piece of paper. Draw a guide line on the back of each paper 2 3/4" in from the edge and score your pencil line with a bradawl. Take care not to press too hard with the bradawl or you will tear the cartridge paper.
Now fold the paper along the scored line. Your first fold will be a mountain fold (as shown above) and the pencil mark will be at the back of the paper. This pencil mark won't be visible when the book is finished.

This is how you fold accordian-style pages. If your first fold was a mountain fold then your next one will be a valley fold (the shape of the fold is self-explanatory). You won't need to measure and mark each fold with a pencil and bradawl as long as you fold CAREFULLY and accurately. Fold both strips of paper in this way until you get to the end.

You should have a small strip of surplus paper at the end. I call this piece the "tail". Cut the tail from only ONE strip of paper, you will need the other one.

One strip of paper won't give you enough pages for your accordian book so you need to join two strips together. Take the "tail" from one strip of paper and glue it to the second strip. Make sure that you glue a valley folded piece to a mountain folded piece and that the tail is at the back of your paper (you don't want the tail to be seen when the book is finished). As shown below.

Once dry, fold all the pages together. They should spring apart as you let go to form an accordian.

Nearly finished! Glue the back of the first page to the inside of the front book cover. The first fold facing upwards should be a valley fold. Make sure that your page covers the edge of the ribbon. Press it firmly and leave to dry. (Don't place it under a weight or you will squish the book cover).

Repeat the process by gluing the back page to the inside back cover and leave the book open to to dry.

When dry, carefully fold the pages up and tie the ribbons together to hold them in place.

Voila! You have just made a delightful book that you can fill with drawings, notes, photos or collage. Here are some sites you can buy handmade books.





  1. WOW!!! I took a bookbinding course ages ago but the accordian book looks so neat. Thanks!

  2. I love that paper!

    Thanks for the link too. I'll actually be teaching classes in a little over a month and this is one of the structures I was planning on teaching.

  3. You are welcome, Kiley. Your books are inspirational!

  4. whata great tutorial! Im going to give it a try!


Please add your comments - I love to hear from you.